# 30113 Page 1 of 1
#30113 - MAST FLOAT
1) Assemble all parts onto shaft.
2) Place lower end of shaft against mast.
3) PVC pipe keeps the float above the masthead. For
17, 18, 20 & 21 installation... trim to 2”.
4) Drills needed: 15/64” when using caps.
3/16” for rivets only.
NOTE: Bearing must be placed - open side towards
center of float.
H-14 / H-16
H-17 / H-18 / H-20 / H-21
Position as shown.
Be sure Float has
complete 360 degree
rotation.
Drill mast and rivet
single (long rivet with
cap) to hold location.
Bend eye straps to
conform to your mast
curve.
Rivet lower strap (use
shorter rivets and seal
caps).
Rivet upper strap
(without seal caps) (use
long rivets for 17, 18, 20
& 21), this is above
seal.
|
Acer TCO03 User Manual
Audiovox Prestige P 950W User Manual
Black Decker CRUSH MASTER BL14451G User Manual
Bose Bluetooth Bluetooth Headset Series 2 User Manual
Bushnell TRAILSCOUT Nov 00 User Manual
Canon RC 250 User Manual
GE FREE STANDING JGB928SEL User Manual
HP (Hewlett Packard) Hewlett Packard Car Video System Q1910S User Manual
HP (Hewlett Packard) T200 User Manual
Jensen VM8023HD User Manual